0

NZ Website

Rubber Self Healing Injection port and Syringe Filter for Mycology

$20.00 inc. GST

18 in stock

Description

YOUR SET INCLUDES:
  • 20x 20mm /0.79″ Rubber Stopper Self Healing Injection Ports Jar.
  • 20x 13mm 0.22-micron Nylon syringe and air exchange filter (Colour may change depending on availability)
Please note that you will need to make two different size holes in your lids:
  • Injection port(Grey) : 12 mm hole
  • Syringe filter: 4 mm hole
The syringe filter has two sides to it. A thick protruding bit stays on top of the lid as per the pictures, and one that is smaller goes through the lid.
Please note you need to use high temp RTV silicon with this product that needs to be purchased separately, and we do not sell it. Once you have made the lids, they need to dry/cure for at least 24 hours before they are ready to be used in the sterilizer.
DESCRIPTION: 

Widely used for liquid culture, substrate jars, and Grain spawn jars. These items are autoclave-safe and have low to no risk of contamination. Stick your ports to the specified holes with a high temp gasket maker or red RTV silicone.

The injection port allows the needle to pass through multiple times while self-healing. The micron air filter has a vent of .22 microns, allowing the appropriate exchange of gases whilst remaining sterile. Once the adhesive is applied, it withstands autoclave temperatures of over 120 Celsius (250F) at 15psi for extended periods (recommended three hours maximum). Click on Self-healing injection port to find another alternative for this product.

RUBBER INJECTION PORT SPECIFICATIONS:
  • Material: Butyl Rubber
  • Color: Grey
  • Size: 20mm /0.79″(appr.)
  • For 13mm or 1/2 inch diameter hole opening.

NYLON SYRINGE FILTER SPECIFICATIONS

  • Material: Nylon & plastic
  • Color: Green/Blue (or different color depending on availability)
  • Total size: approx. 17.5*17mm
  • Filter outer diameter: approx. 13mm
  • Mesh diameter: approx. 0.22 micron

If you would like to make your own mycology lids, check out our DIY page to Make Lids for Liquid Culture and Grain Spawn.

Shipping Cost – The product is shipped via Australia Post using Express Post service for $5.80. If multiple items are in the cart with varying shipping costs, only the highest shipping cost for a product in the cart will be charged.

Handling time- This product has 0 days handling time and is shipped the same day if ordered before 12 pm. However, it’s important to note that if other items are in your cart, the handling time may vary based on the handling time associated with those additional items. Handling time is not guaranteed during the busy holiday period.

Shipping time- Australia Post guarantees express post is delivered the next day in metro regions of Capital cities, but give it anywhere from 1-3 days for this package to reach you. Shipping times are not guaranteed during the busy holiday period.

 

Please enter your email address to receive your Quote.

Join Waitlist We will inform you when the product arrives in stock. Please leave your valid email address below.
    0
    Your Cart
    Your cart is emptyReturn to Shop
      Calculate Shipping
      Apply Coupon
        SubmarkLogo_4